Installing the Cable Management Tray and Arm

Installing the Cable Management Arm Tray

The Cable Management Arm is intended to be installed on sliding rail kits only.

The CMA can be installed on either the right or left mounting rail, depending on how the cables must be routed from the device.

1. Fit the ends of the tray between the ends of the mounting rails at the back of the device, then slide the tray towards the device until it latches.
   
2. In preparation for installing the CMA, press the catch at the center of the retention latch, and rotate the latch downwards.

Installing the Cable Management Arm

1. Ensure that the retention latch is down.
   
2. Fit the latch on the front end of the CMA onto the innermost bracket of the rail assembly at the back of device until the latch engages.
3. Fit the latch on the unattached end of the CMA onto the outermost bracket of the rail assembly until the latch engages.

Next, see Routing Cables through the Cable Management Arm.

The post Installing the Cable Management Tray and Arm appeared first on Fortinet Cookbook.