Viewing the FortiGate or FortiExtender Modem List

1. Enabling the FortiGate modem interface

The modem configuration is hidden in the FortiGate GUI by default. Enter the CLI commands shown on the right to enable it. 

Log in and out to refresh the GUI page.

config system modem
 set status enable
end

2. Viewing the supported modem lists

1. Enabling the FortiGate to show FortiExtender configurations

Enable the Control And Provisioning of Wireless Access Points (CAPWAP) on the port which the FortiExtender is connected to. This allows the FortiExtender to communicate with the FortiGate using CAPWAP. Enter the following CLI commands:

config system interface
 edit [port]
  append allowaccess capwap
end

The FortiExtender configuration is hidden in the FortiGate GUI by default. Enter the following CLI commands to enable it:

config system global
 set fortiextender enable
 set wireless-controller enable
end

2. Authorizing the FortiExtender

3. Viewing the supported modem lists

Go to Network > FortiExtender select Configure Settings.

Select Supported Modems to go to the supported modem lists.

Click the FortiGuard button to get the latest version of the supported modem lists, and then select the plus button to expand either list.