FortiAntenna-M22 Installation Guide

Note: The FortiAntenna-M22 is suitable for poles one to four inches (approx 2.5-10 cm) in diameter.

1. Place item number 2 on the antenna, as illustrated in the above drawing.
   Align with the screw holes.
2. Connect item 2 to the antenna with spring washers (11), flat washer (10), and nuts (12).
3. Tighten the nuts at a torque of 30 in lbs (3.4 Nm).
   
4. Connect item 3 to item 2 ONLY, as illustrated in the above image, with items 6, 7, 8, and 13.
   Leave screw slightly loose.
5. Connect item 3 to item 5 as illustrated below, using items 6, 7, 8, and 13.
   Leave screw slightly loose.
   
6. Attach items 4 and 5 to the pole as illustrated below, then connect them using items 6, 7, and 9.
   
7. Adjust the desired angle, and fully tighten the loose screws from steps 4 & 5.
8. Tighten the nuts at a torque of 30 in lbs (3.4 Nm).

Wall Mounting

The post FortiAntenna-M22 Installation Guide appeared first on Fortinet Cookbook.