FortiAP S322CR Installation Guide

IMPORTANT NOTE: The device must be professionally installed and must use the supplied antennas.

The unit is designed for outdoor use and may be attached to either a pole or wall. A waterproof connector is supplied to ensure a watertight seal for connecting the Ethernet cable to the device.

Note: The device can be mounted either outdoors or indoors. The included PoE injector and surge protector must be mounted indoors, as they are not weatherproof.

To mount the device on a wall

1. Using the wall-mount base as a template, mark the location of the mounting bolt holes on a flat wall surface.
2. Drill the mounting holes in the marked locations.
3. Fasten the wall-mount base securely to the back of the unit using the provided mounting screws.
4. Attach the unit and base assembly to the wall using the provided mounting bolts.
   
5. Securely tighten the mounting bolts.
   

To mount the FortiAP unit on a pole

1. Fasten the wall-mount base securely to the back of the unit using the provided mounting screws.
2. Attach the pole-mount bracket to the wall-mount base using the provided screws.
   The pole-mount bracket can be attached either vertically or horizontally, as required.
   
3. Loop the provided pole strap through the slots on the pole-mount bracket and then around the pole.
4. Tighten the strap with an appropriate screw driver and ensure that the device is firmly in place.

The post FortiAP S322CR Installation Guide appeared first on Fortinet Cookbook.